RV Water Pump Repair in Dallas–Fort Worth
Pump runs but nothing comes out, keeps turning on by itself, or won't stop? An independent mobile RV technician can find the leak or the failed part at your RV.
Independent mobile RV technicians come to you — home, storage lot or RV park.

Signs your RV water pump or plumbing needs a technician
How owners usually describe it, and what it often means. Causes here follow the pump maker Pentair-Shurflo's troubleshooting guide.
- The pump runs but no water comes out
The pump can't pull water: an empty tank, a clogged inlet strainer, air sucked in at a loose fitting on the inlet side, a stuck check valve, or valves still set for winter.
- The pump turns on by itself every few minutes
Water is leaking somewhere on the pressure side — a fitting, a faucet, the toilet valve — or the city water inlet valve is letting water back.
- The pump won't shut off
A leak on the output side, a pressure switch that has failed, or an empty tank so the pump never builds pressure.
- The pump is loud
Loose or over-tightened mounting feet, a floor that drums, rigid pipe that carries the noise, or air in the system.
- Weak water pressure
A partly clogged strainer, a kinked line, low voltage at the pump, or a worn pump.
- Water under the RV or a wet cabinet
A leaking fitting, a cracked line after a freeze, or a leaking water heater or toilet. Find it early — water in the floor causes rot.
What to check before you call
- Water in the tank
Check the fresh tank level — and remember the tank gauge can be wrong.
- The strainer
Unscrew the clear strainer bowl next to the pump and rinse the screen. Some RVs have a second strainer inside the tank.
- Winter valves
If the RV was winterized, make sure the bypass and antifreeze valves are back to normal use.
- Voltage
Pentair-Shurflo says to check that the pump gets its rated voltage, within 10%. A weak battery makes a slow, weak pump.
- Find the leak
If the pump cycles, close every faucet, turn on the pump and look for drips at the pump fittings, under sinks, behind the toilet and at the water heater.
- Fittings on the inlet side
A loose fitting between the tank and the pump lets in air instead of water. Hand-tighten plastic fittings — don't force them.
Stop here. Don't cut into water lines or take the pump apart if you're not sure. A wet floor or a leak you can't find needs a technician with a moisture meter.

What the technician does
- Checks voltage and the ground at the pump.
- Cleans the strainer and checks the inlet side for air leaks.
- Tests the pressure switch and the check valve.
- Pressure-tests the lines to find leaks, including the toilet valve, faucets and the city water inlet.
- Replaces fittings, lines or the pump, and checks the floor near any leak with a moisture meter.
- Explains what failed and gives you a price first.

What RV plumbing repair costs
Typical 2026 ranges from an industry cost guide. They are U.S.-wide figures, not Dallas prices.
| Repair | Typical range |
|---|---|
| Simple leak repair | about $100 |
| Plumbing repair | $100–1,000+ |
Source: Camping World, “Mobile RV Repair Cost Guide”, July 2026.
Typical range in 2026 — not a quote. The independent technician gives the price after diagnosis.
A new pump costs more or less depending on the model and flow rate; the technician quotes it with labor. Technician labor in 2026 cost guides is about $140–200 an hour, and most mobile technicians charge a trip or diagnostic fee.
Prices checked November 2026.
RV water pump questions
How can I tell if my RV water pump is bad?
If it gets power, the tank has water, the strainer is clean and there is no air leak on the inlet side, but it still doesn't move water or build pressure — the pump itself is likely worn. A technician can confirm before you buy a new one.
Why does my water pump run but there's no water pressure?
Usually the pump is pulling air: an empty tank, a clogged strainer, a loose fitting on the inlet side or valves set for winter. Check those first.
Why does my RV water pump keep running or cycling?
Cycling with all faucets closed means a leak on the pressure side or a leaking toilet or city water valve. Running without stopping can also be a failed pressure switch or an empty tank.
Can I replace an RV water pump myself?
Many owners do: it is a 12-volt pump with two water connections. Turn off its power first, relieve the pressure and catch the water. If the problem is a leak you can't find, a technician saves time.
Will an RV water pump run without water?
It will run, but it shouldn't for long — it can't prime and it wears out. If it runs and nothing comes out, turn it off and check the tank and the strainer.
Request a technician
Tell us what's wrong and where your RV is. We send your request to independent mobile RV technicians who serve that part of DFW.