Independent mobile RV technicians across Dallas–Fort WorthFort WorthContact
Dallas RV Mechanic

RV Furnace Blowing Cold Air: What's Normal, What Isn't

An RV furnace blows cool air for a short time on every cycle — that part is normal. Cold air that keeps coming, or a few minutes of cold air and then silence, means the burner didn't light.

Hand held over a floor heat register in an RV to feel the air

If you smell propane: leave the RV, close the tank valve if it's safe to do so, and call 911 from a safe distance.

What the cold air tells you

Times from Suburban's user manual; the rest from Camping World's furnace troubleshooting guide (October 2026).

  • Cool air for the first minute — normal

    The fan starts before the burner. Allow about 30 seconds for the fan and up to 30 seconds more for the burner to light.

  • Cooler air after the heat shuts off — normal

    When the room is warm enough, the burner stops and the fan keeps running a couple of minutes to cool the furnace (Suburban's manual: about 2 minutes).

  • Cold air for a few minutes, then the fan stops

    The burner failed to light three times and the furnace locked out. The fan clears the furnace for a few minutes, then stops. See RV furnace won't ignite.

  • Lukewarm air from the ceiling unit

    That is the heat strip in the rooftop air conditioner, not the furnace. Dometic's manual says heat-strip mode is supplemental heat only and won't replace a furnace in cold weather. Set the thermostat to Furnace.

  • Warm at some registers, cold at others

    A closed register or a crushed or disconnected duct. Open all registers; if one stays cold, the duct under the floor needs a technician.

  • Heat for a few minutes, then cold, then heat again

    Usually airflow: the furnace overheats and its limit switch shuts the burner off. If it stays off for five minutes, the furnace locks out.

What to check

None of these involve opening the furnace.

  • Thermostat mode

    Furnace or Heat — not heat strip or heat pump. A heat pump in the rooftop unit also heats less as it gets colder outside.

  • Propane

    Open the tank valve all the way and check the tank isn't empty. If a stove burner lights and burns steadily, propane is reaching the RV.

  • 12-volt power

    A weak battery turns the fan too slowly and the furnace won't light. Plug in or charge the battery.

  • Return grille and registers

    Move anything stored against the furnace's return grille and open the floor registers. Suburban's manual: don't restrict the air going to the furnace or the warm air leaving it.

  • No duct boosters

    Suburban says booster fans in the ducts make the furnace cycle on its limit switch and the sail switch work erratically.

  • Reset once

    Turn the thermostat off and back on. If you still get only cold air after three attempts, stop and call a technician.

Stop here. Don't remove the furnace, open the burner or adjust the gas valve. If you smell propane, leave the RV and close the tank valve from outside.

Duffel bag and storage bin pushed against the furnace return air grille inside an RV

What the technician checks

When the burner doesn't light, a mobile technician checks the gas pressure at the furnace, the burner, the electrode and the gas valve; tests the sail switch and the limit switch; and reads the control board — Dometic boards flash a code. If the furnace heats but some registers stay cold, the technician checks the ducts under the floor. You get the price before any part is replaced. See RV furnace repair for typical 2026 costs.

Propane work in Texas

In Texas, work on an RV's propane system — gas lines, the regulator, gas valves and burners — is done by technicians licensed by the Railroad Commission of Texas. Before propane work starts, ask the technician for their license number. You can look it up on the Railroad Commission website.

Cold air questions

Why is my RV furnace blowing cold air?

Either the burner hasn't lit yet (normal for the first minute), it failed to light (no propane, low battery, sail switch, igniter), or the thermostat is running the air conditioner's heat strip instead of the furnace.

Why does my RV furnace blow cold air after working for a while?

Check the propane first — a tank can run out overnight. A battery that ran down overnight, or a furnace overheating because of blocked airflow, can also stop the burner while the fan keeps going.

How do I reset my RV heater?

Turn the thermostat off, wait a minute and turn it back on. On Dometic furnaces you can also switch the furnace's power switch off and on. If it doesn't light after three attempts, stop and call a technician.

How can I tell if the thermostat is the problem?

If the fan starts when you set Furnace and raise the temperature, the thermostat is calling for heat — the problem is in the furnace. If nothing starts and the battery, fuse and furnace switch are fine, a technician checks the thermostat and its wiring.

Request a technician

Tell us what's wrong and where your RV is. We send your request to independent mobile RV technicians who serve that part of DFW.

Request a technician